DigiDesign Digi 002 Getting Started Manual page 35

Recording a Digital Source
If you are recording from an optical or S/PDIF
device, you will need to select a Clock Source. In
most cases, you will synchronize the Pro Tools
clock to the external device.
To configure Pro Tools LE for a digital source:
Connect an ADAT or Optical S/PDIF format
1
device to the Optical In connector, or an RCA
S/PDIF format device to the RCA S/PDIF In con-
nector on the back of the Digi 002.
Choose Setup > Hardware.
2
Make sure the correct digital input option is
3
selected for your setup. When you select RCA
S/PDIF, the Optical ports are available for stan-
dard ADAT Optical (or "Lightpipe") input.
When you select Optical S/PDIF, the RCA digital
input connector is inactive.
You can use only one pair of S/PDIF inputs
(either RCA or Optical) at a time.
From the Clock Source pop-up menu, select
4
Internal if you are synchronizing the external
device to Digi 002 or Digi 002 Rack. If you are
synchronizing the Pro Tools clock to the exter-
nal device, select ADAT, RCA (S/PDIF) or Optical
(S/PDIF), depending on where you connected
your digital device.
Your digital input device must be connected
and powered on. If your input device is not
powered on, leave the Clock Source set to
Internal.
Configuring I/O Setup
Using the I/O Setup dialog, you can label
Pro Tools LE input, output, insert, and bus sig-
nal paths. The I/O Setup dialog provides a graph-
ical representation of the inputs, outputs, and
signal routing of the Digi 002 and
Digi 002 Rack.
Pro Tools LE has default I/O Setup settings that
will get you started. Use the I/O Setup dialog
only if you want to rename the default I/O
paths.
To rename I/O paths in I/O Setup:
Choose Setup > I/O.
1
I/O Setup dialog, Input tab (Digi 002 shown)
Click the Input, Output, Insert, or Bus tab to
2
display the corresponding paths.
To change the name of a path or subpath,
3
double-click directly on the Path Name, type a
new name for the path, and press Enter (Win-
dows) or Return (Macintosh).
Chapter 4: Launching and Configuring Pro Tools LE 27