DigiDesign Digi 002 Getting Started Manual page 109

Mixer Inputs
Inputs 1–4 These inputs accept microphone-,
line-, or instrument-level signals, and provide
variable gain with the Input Gain control on the
Digi 002 top panel.
Phantom power is available to Inputs 1–4, in
channel pairs, using the Phantom Power
switches on the back panel of Digi 002.
Inputs 5–8 These inputs accept line-level signals
and are switchable between –10 dBV and +4 dBu
with the operating level switches on the
Digi 002 back panel.
Alt Src Inputs These inputs are active in Stand-
alone mode, allowing you to connect and mon-
itor alternate audio sources such as CD players
or tape decks. The signal from the Alt Src Inputs
can be routed directly to the Monitor and Head-
phone Outputs (by pressing the Alt Src to Mon
switch) or to Input channels 7–8 (by pressing
the Alt Src to 7–8 switch).
When Alt Src to 7–8 is enabled, analog inputs
7–8 (1/4-inch TRS connectors on the back panel
of Digi 002) are disabled.
S/PDIF Digital Inputs In Stand-alone mode, you
can activate these digital inputs so that they ap-
pear on inputs 5–6, allowing you to bring a ste-
reo digital signal into the Digi 002. (See "Digital
Audio Connections in Stand-Alone Mode" on
page 102.)
Sends
Each of the eight channels of Digi 002 can send
to any or all of the four available sends at the
same time. Sends can be either pre- or post-
fader.
Send A Routes the input signal to the internal
Delay processor
Send B Routes the input signal to the internal
Reverb processor
Send C Routes the input signal to output 7 on
the back panel of Digi 002
Send D Routes the input signal to output 8 on
the back panel of Digi 002
All the send assignments in Stand-alone
mode are fixed, and cannot be changed.
Dynamics
Input channels 1–4 have a dedicated, in-line
compressor, with controls for the following pa-
rameters:
• Input gain
• Threshold
• Compression ratio
• Attack and release times
• Hard or soft knee (slope)
• Phase inversion
• Output gain
EQ
Each of the eight Input channels has a dedi-
cated, in-line 3-band equalizer, consisting of the
following:
• Switchable high pass/low shelf EQ band
• Parametric EQ band
• Switchable low pass/high shelf EQ band
These EQ bands can be used in conjunction
with the built-in hardware high-pass filters
available on Inputs 1–4.
Chapter 10: Using Digi 002 as a Stand-Alone Mixer 101