DigiDesign Digi 002 Getting Started Manual page 111

Press the far right-hand Channel Select switch
6
to save the preference settings.
Press the Escape (Esc) switch twice to exit Util-
7
ity mode.
Digital Input Format
You can set Digi 002 to receive S/PDIF input at
the RCA Input connector or the Optical Input
port on the back panel of Digi 002. See "Digital
Audio Connections" on page 61 for details on
S/PDIF input format.
In Stand-alone mode, the RCA and Optical ports
accept S/PDIF signals at sample rates up to
48 kHz.
RCA S/PDIF IN
Input
OUT
S / PDIF
Optical
Input port
Digital input connectors (back panel)
To change the digital input format for Inputs 5–6:
In Stand-alone mode, press the Utility (F1)
1
switch.
Press the illuminated Channel Select switch
2
under Pref.
Press the illuminated Channel Select switch
3
under SPDF (S/PDIF).
Press the illuminated Channel Select switch
4
repeatedly to toggle the digital format to RCA or
Optical.
Press the Escape (Esc) switch to exit SPDF pref-
5
erences.
Press the far right-hand Channel Select switch
6
to save the preference settings.
964530300294856
SERIAL NUMBER
OPTICAL
OUT IN
MIDI OUT 2 MIDI OUT 1
Press the Escape (Esc) switch twice to exit Util-
7
ity mode.
Only one S/PDIF input pair can be used at a
time. For example, if you use the optical in-
put for S/PDIF data, you cannot use the
RCA inputs.
Digital Clock Source
When you connect an external digital source,
you can set Digi 002 to synchronize to external
Word Clock (the clock signal coming from the
device) or internal Word Clock (generated by
Digi 002). In most cases, such as with DAT
decks, you will use external clock.
To change the clock source for the digital inputs
on Inputs 5–6:
In Stand-alone mode, press the Utility (F1)
1
switch.
Press the illuminated Channel Select switch
2
under Pref.
Press the illuminated Channel Select switch
3
under WClk (Word Clock).
Press the illuminated Channel Select switch
4
repeatedly to toggle the clock source to Internal
or S/PDIF (external).
Press the Escape switch to exit SPDF prefer-
5
ences.
Press the far right-hand Channel Select switch
6
to save the preference settings.
Press the Escape (Esc) switch twice to exit Util-
7
ity mode.
When the Word Clock source is set to S/PDIF
(external), the Sample Rate indicator flashes to
indicate that no clock signal is present, or that
Digi 002 is not receiving valid clock signal. The
Sample Rate indicator lights solid to indicate
Digi 002 is receiving valid clock signal.
Chapter 10: Using Digi 002 as a Stand-Alone Mixer 103