PRODUCT OVERVIEW
1. Test probe (-) L1
2. Test probe (+) L2
3. LEDs for voltage indication
4. LED for single-pole test
5. Right and left LED, phase rotation indication
6. LED for continuity
7. LCD for displaying voltage
8. Contact electrode for double-pole test of
phase rotation and single-pole test.
9. Torch button on reverse
10. Positive LED
11. Negative LED
12. Battery compartment
13. Anti-leakage piece
MEASURING
•
Before measuring, perform a self-test of the unit.
•
Connect the two test probes L1 and L2.
•
The continuity LED will be lit and an audible tone will be heard.
•
Before any test, check the unit on a known voltage source.
VOLTAGE TEST
•
Always hold the test probes by the
handles behind the finger guards.
•
An audible tone will be heard when an AC
voltage and a negative DC voltage are
indicated.
•
The maximum switch-on time is 30
seconds. When this time has elapsed you
must wait 10 seconds before retesting.
•
Connect the probes to the voltage source,
observing polarity of the test probes.
Note: L2 is the positive probe, while L1 is
the negative.
•
For AC voltage the value is indicated
on the three LEDs and on the LCD. The
positive and negative LEDs will illuminate
and the buzzer will sound.
4