Weider 9000 User Manual page 7

4. Attach one of the Uprights (3) to the Right Base
(1) with four M10 x 68mm Bolts (46), two Support
Plates (14), and four M10 Nylon Locknuts (49).
Do not tighten the Nylon Locknuts yet.
Repeat this step with the other Upright (not
shown) and the Left Base (not shown).
5. Press a 50mm Square Inner Cap (43) into the top
of the right Upright (3).
Slide a Safety Spotter (15) onto the right Upright
(3) and engage the Knob (17) into the lowest
adjustment hole in the Upright. Turn the Knob
clockwise until it is tight.
Slide a Weight Rest (16) onto the right Upright (3)
and engage the Knob (17) into an adjustment hole
in the Upright. Turn the Knob clockwise until it is
tight.
Repeat this step with the left Upright (not
shown).
6. Attach the Crossbar (7), with the decal on the
side shown, to the right Upright (3) with four M10
x 68mm Bolts (46), two Support Plates (14), and
four M10 Nylon Locknuts (49). Do not tighten
the Nylon Locknuts yet.
Attach the Crossbar (7) to the left Upright (not
shown) in the same manner.
4
49
5
15
6
49
7
3
49
14
1
14
46
16
17
43
3
Adjustment
Holes
46
14
3
14
Decal
7