Weider 9000 User Manual page 15

33. Orient the Seat (70) with the wide end on the side
shown. Attach the Seat to the Bench Frame (63)
with four M6 x 16mm Bolts (80).
34. Press three 45mm Square Inner Caps (42) into
the Leg Lever (66).
Attach the Weight Tube (65) to the Leg Lever (66)
with an M8 x 58mm Bolt (41), two M8 Washers
(53), a 13mm x 10mm Spacer (75), and an M8
Nylon Locknut (48).
Press a 25mm Round Inner Cap (45) into the
indicated end of the Weight Tube (65). Press the
25mm Round Angle Cap (76) onto the other end
of the Weight Tube.
35. Lubricate the M10 x 68mm Bolt (46) with grease.
Attach the Leg Lever (66) to the Front Leg (64)
with the Bolt and M10 Nylon Locknut (49).
36. Press the six 19mm Round Inner Caps (81) into
the ends of the three Pad Tubes (71).
Slide a Pad Tube (71) into the hole in the Front
Leg (64). Slide two Foam Pads (72) onto the
ends of the Pad Tube.
Slide the other two Pad Tubes (71) into the holes
in the Leg Lever (66). Slide two Foam Pads (72)
onto each Pad Tube.
33
70
Wide
End
63
80
34
42
41
45
65
35
66
36
72
72
81
71
81
15
80
42
66
76
75
53
48
53
42
49
46
Lubricate
64
72
64
81
71
81
66
72
72
72