Weider 9000 User Manual page 11

18. Identify the High Cable (31), which is the
shorter of the two remaining cables. Route the
eyelet end of the Cable up through the indicated
hole in the Top Frame (8).
Wrap the High Cable (31) around a 90mm Pulley
(24). Attach the Pulley inside of the Top Frame (8)
with an M10 x 65mm Bolt (54), two 15mm x
13mm Spacers (39), two M10 Washers (52), and
an M10 Nylon Locknut (49).
19. Route the High Cable (31) down through the indi-
cated hole in the Top Frame (8).
Wrap the High Cable (31) around a 90mm Pulley
(24). Attach the Pulley and a Cable Trap (26)
inside of the Top Frame (8) with an M10 x 65mm
Bolt (54), a 15mm x 13mm Spacer (39), a 15mm
x 10mm Spacer (40), two M10 Washers (52), and
an M10 Nylon Locknut (49).
20. Remove the 90mm Pulleys (24) from the pre-
assembled Pulley Plates (28).
Wrap the High Cable (31) under a 90mm Pulley
(24). Attach the Pulley and a Cable Trap (26) to
the second hole from the top of the two Pulley
Plates (28) with an M10 x 45mm Bolt (57) and an
M10 Nylon Locknut (49).
21. Route the High Cable (31) up through the indicat-
ed hole in the Top Frame (8).
Wrap the High Cable (31) around a 90mm Pulley
(24). Attach the Pulley, a Cable Trap (26), a
15mm x 8mm Spacer (55), and a 15mm x 10mm
Spacer (40) to the Top Frame (8) with an M10 x
68mm Bolt (46), the two attached Support Plates
(14), and an M10 Nylon Locknut (49). Do not
overtighten the Bolt; the pulley must be able
to pivot easily.
18
49 24
52
39
31
19
31
20
21
8
11
52 8
39
54
26
24
49
52
40
39
54
8
49
31
24
28
26
28
55
31
26
40
24
49
46
14
6
52
57