11
SERVICE WORK ON THE CHASSIS
11.48
Changing the hydraulic clutch fluid
Warning
Environmental hazard Hazardous substances cause environmental damage.
–
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
(All 250/300 models)
–
Move the clutch fluid reservoir mounted on the handlebar to a horizontal posi-
tion.
–
Remove screws
–
Remove cover
–
Check the fluid level.
Fluid level under top edge of con-
tainer
L01222-10
»
If the level of the fluid does not meet specifications:
–
–
Position the cover with the membrane. Mount and tighten the screws.
x
(All 125/150 models)
–
Move the clutch fluid reservoir mounted on the handlebar to a horizontal posi-
tion.
–
Remove screws
–
Remove cover
L00953-10
–
Fill bleeding syringe
Bleed syringe (50329050000)
Hydraulic fluid (15) (
–
On the slave cylinder of the clutch, remove bleeder screw
ing syringe
101725-10
–
Inject the liquid into the system until it escapes from bore hole
ter cylinder without bubbles.
–
To prevent overflow, drain fluid occasionally from the master cylinder reservoir.
–
Remove the bleeding syringe. Mount and tighten the bleeder screw.
–
Correct the fluid level of the hydraulic clutch.
Guideline
Fluid level under top level of con-
tainer
L00953-11
–
Position the cover with the membrane. Mount and tighten the screws.
.
1
with membrane
2
3
Correct the fluid level of the hydraulic clutch.
Brake fluid DOT 4 / DOT 5.1 (
Info
Wash off overflowed or spilled brake fluid immediately with water.
.
1
with membrane
2
3
with the appropriate hydraulic fluid.
4
p. 125)
.
4
.
4 mm (0.16 in)
p. 124)
.
and mount bleed-
5
4 mm (0.16 in)
64
of the mas-
6