Connecting Xr Aluma-Pro, Xr Edge, Xr-A Gun, Or Xr-A Python - Miller Millermatic 252 Owner's Manual

5-7. Connecting XR Aluma-Pro, XR Edge, XR-A Gun, Or XR-A Python

3/32 in.
(2.4 mm)
3
2
.
Be sure to trim liner to proper extension.
.
A complete Parts List is available at www.MillerWelds.com
1
.
1
2
3
Trim excess liner from end of gun
so no more than 3/32 in. (2.4 mm) of
liner extends past wire outlet guide.
4
Loosen securing knob. Insert gun
end through opening until it bottoms
against drive assembly (make sure
gun end does not touch drive rolls).
Tighten knob.
Be sure to change drive rolls to the
4
proper size and type.
5
Insert plug into receptacle, and
tighten threaded collar.
.
5
XR Edge guns prior to serial no.
LE079101 require an adapter
cord (part no. 195 498).
Gun End
Gun Liner
Wire Outlet Guide
Gun Securing Knob
Gun Trigger Plug
If Aluma-Pro push/pull gun has
a listed SUP value, set the
power source to match the
SUP value (see Section 6-5).
Ref. 804 910-A / 804 936-A
OM-230 693 Page 17