Connecting Spoolmatic) 15A Or 30A Or Spoolmate 200 Gun; Connecting Xr-Aluma-Pro Or Xr-Aluma-Pro Lite - Miller Millermatic 255 Owner's Manual

5-14. Connecting Spoolmatic) 15A Or 30A Or Spoolmate 200 Gun

8
9
Tools Needed:
3/4 in.

5-15. Connecting XR-Aluma-Pro Or XR-Aluma-Pro Lite

.
Be sure to trim liner to proper extension.
3/32 in.
(2.4 mm)
2 3
OM-279299 Page 26
.
A complete Parts List is available at www.MillerWelds.com
2
7
3
4
1
1 in.
6
5
2
Tools Needed:
5 4
1 Gun Trigger Plug
Insert plug into receptacle, and tighten
threaded collar.
2 Weld Cable
3 Shielding Gas Hose
Route weld cable and gas hose
through opening in panel.
4 Drive Casting
Remove the 3/4 in. bolt from the drive
casting. Use bolt to connect spoolgun
weld cable to drive casting.
5 1/2-13 x 3/4 in. Bolt (282942)
6 Lock Washer (602216)
7 Washer (602247)
8 Gas Hose Routing Hole
To route gas hose through rear panel,
drill 1 in. hole through bottom of rear
plastic bezel. Align drill with pilot dim-
ple in plastic bezel visible from inside
wire drive compartment.
9 Gas Hose Fitting
Route shielding gas hose through wire
drive compartment, out opening in rear
panel, and up to regulator/flowmeter.
Connect gas hose fitting
regulator/flowmeter.
3
1 Gun End
2 Gun Liner
3 Wire Outlet Guide
Trim excess liner from end of gun
so no more than 3/32 in. (2.4 mm) of
liner extends past wire outlet guide.
4 Gun Securing Knob
Loosen securing knob. Insert gun
end through opening until it bottoms
against drive assembly (make sure
gun end does not touch drive rolls).
Tighten knob.
Be sure to change drive rolls to the
proper size and type.
5 Gun Trigger Plug
Insert plug into receptacle, and
tighten threaded collar.
1
803463 / 282952A
to
282999