Connecting To Weld Output Terminals; Installing Work Cable And Clamp - Miller Millermatic 252 Owner's Manual

5-4. Connecting To Weld Output Terminals

Tools Needed:
3/4 in. (19 mm)
!
Turn off power before connecting to
weld output terminals.
!
Failure to properly connect weld
cables may cause excessive heat
and start a fire, or damage your ma-
chine.

5-5. Installing Work Cable And Clamp

Tools Needed:
3/4 in.
.
A complete Parts List is available at www.MillerWelds.com
4
1
Do not place
anything between
weld cable terminal
and copper bar.
2
3
Correct Installation
1 Weld Output Terminal
2 Supplied Weld Output Terminal Nut
3 Weld Cable Terminal
4 Copper Bar
Remove supplied nut from weld output
terminal. Slide weld cable terminal onto
2
3
Incorrect Installation
weld output terminal and secure with nut so
that weld cable terminal is tight against
copper bar. Do not place anything
between weld cable terminal and copper
bar. Make sure that the surfaces of the
weld cable terminal and copper bar are
clean.
1 Work Cable
2 Boot
Route cable through front panel
opening. Slide boot onto work
cable.
3 Negative (−) Output Terminal
Connect cable to terminal and
cover connection with boot.
Close door.
1
803 778-A
804 909-A
OM-230 693 Page 15