NordicTrack Cxt 1400 Elliptical User Manual page 7

5. While another person holds the Upright (3), connect
the Upper Wire Harness (48) to the Lower Wire
Harness (49). Gently pull the upper end of the
Upper Wire Harness to remove any slack, and
insert the Upright into the Base (1). Attach the Upright
with an M8 x 69mm Button Bolt (80), an M8 Split
Washer (90), and an M8 Jamnut (79). Do not tighten
the Button Bolt yet; make sure that the Jamnut is
in the hexagonal hole in the Base.
Next, finger tighten two M8 x 23mm Button Screws
(84) with M8 Split Washers (90) into the Base (1). Do
not tighten the Button Screws yet.
Attach the Water Bottle Holder (22) to the Base (1)
with two M4 x 14mm Screws (104).
6. Orient the Transport Handle (119) as shown, and attach
it to the Upright (3) with two M8 x 112mm Button Bolts
(123) and two M8 Jamnuts (79).
While another person holds the Pulse Bar (4) near the
Upright (3), connect the two connectors on the Upper
Wire Harness (48) to the corresponding connectors on
the Pulse Wire (121). Insert the Wire Harnesses into the
Upright, and attach the Pulse Bar to the Upright with
three M8 x 23mm Button Screws (84) and three M8 Split
Washers (90).
Orient one of the Upright Covers (17) as shown, and hold
it against the Upright (3). Attach the Upright Cover with
two M4 x 16mm Round Head Screws (101). Attach the
other Upright Cover in the same way.
7. The Console (5) requires four "D" batteries; alkaline
batteries are recommended. Remove the battery cover
from the bottom of the Console. Next, insert four batter-
ies into the battery compartment; make sure that the
batteries are oriented as shown by the diagram
inside the battery compartment. Reattach the battery
cover.
8. While another person holds the Console (5) near the
Upright (3), connect the two wire harnesses on the
Console to the corresponding connectors on the Upper
Wire Harness (48). Insert the excess wire harness into
the Upright (3). Next, attach the Console to the Upright
with four M4 x 16mm Round Head Screws (101). Be
careful to avoid pinching the wire harnesses.
5
80
90
90
84
6
119
123
3
90
84
17
101
7
5
Batteries
8
101
7
3
48
49
79
90
84
104
22
1
79
84
90
121
48
4
101
17
Batteries
Battery
Cover
Wire
Harnesses
48
3
90
5