Changing The Current Scsi Ids - HP 220mx User Manual

Changing the Current SCSI IDs

READY > ADMIN * > SCSI ID'S * > SET ID'S *
NOTE If you are unfamiliar with basic SCSI addressing or LUN addressing, refer to
Appendix B.
Start with READY in the display.
1. Press
2. Enter the administration password.
3. Press
4. VIEW ID'S displays. Press
5. Press
Chapter 3
until ADMIN * displays, and then press
NEXT
Instructions for entering this password are in "Entering the Administration
Menu Password" previously in this chapter.
until SCSI ID'S displays, and then press
NEXT
.
ENTER
BUS 1 * displays. If you want to change the IDs on Bus 1, press
If you want to change the IDs on Bus 2, press
then press .
ENTER
If you are using basic SCSI addressing (LUN mode OFF):
JKBX ID # LUN # or DRV # ID # LUN # displays. (JKBX ID #
stands for the current ID of the jukebox controller, LUN # is the current logical
unit number, and DRV # ID # is the current ID setting for the displayed drive
number.) When using basic SCSI addressing, the LUN # is always 0.
If you are using LUN addressing (LUN mode ON):
JKBX BUS 1 # or DRVs BUS 1 # displays on Bus 1, or DRVs BUS 2 #
displays on Bus 2. ("#" is the current ID for the jukebox controller and drives
when LUN mode is ON.)
until the setting you wish to change displays, and then press
NEXT
The # (current ID) begins flashing.
ENTER
until SET ID'S displays and then press
NEXT
until BUS 2 * displays and
NEXT
Operating the Jukebox
Setting the SCSI IDs
.
.
ENTER
.
ENTER
.
ENTER
3-17