Figure 1-2 Connecting A 4- Or 6-Drive Jukebox - HP 220mx User Manual

Setting Up the Jukebox
Connecting a 4- or 6-Drive Jukebox
Refer to the following diagram in the next steps.
3. Select single-ended ("A") or differential ("B") interface using the SCSI
4. Connect a cable between your host computer and either port of the jukebox
5. Plug a SCSI terminator into the unused SCSI port of interface type you chose
Figure 1-2 Connecting a 4- or 6-Drive Jukebox
6. Plug a SCSI terminator into one of the SCSI ports on the unused interface.
1-10
interface selection switch (see the arrow on the diagram ).
The diagram shows connecting a cable to the differential ("B") interface.
SCSI connectors of your selected interface type (the example diagram shows
using the "B2" port on the differential interface).
Route the cable through the slot at the bottom of the right side ("C").
(the example diagram shows the terminator at "B1" because "B2" was used for
the cable ).
If you are using the differential interface, use a 68-pin high-density terminator. If
you are using the single-ended interface, use a 50-pin high-density active
terminator.
Only one terminator is necessary on an unused interface.
The example diagram shows the terminator on the single-ended interface
connector "A2" but the terminator could have been placed on "A1".
Use an active terminator if you are terminating a single-ended interface.
Chapter 1