HP 220mx User Manual page 34

WARNING
NOTE
Setting Up the Jukebox
Moving or Shipping the Jukebox
3. Switch jukebox power OFF ("8" on Figure 1-1).
4. Remove the right side lower access panel by pulling on the bottom of the panel
and then lifting it off ("6" Figure 1-1).
If screws are installed on the bottom corners of the panel, use a flatblade
screwdriver or T-15 Torx driver to remove the screws.
5. Remove the power cord and the SCSI cable connections.
6. Loosen the 1/2-inch nut securing each leveler foot and screw the four feet up to
raise them away from the floor.
7. Remove the chocks from the four caster wheels on the bottom of the jukebox.
Push the jukebox only from the right or left sides (see Figure 1-1). Pushing the
jukebox from either the front or back sides could result in the jukebox tipping
over if a wheel catches on an obstacle.
8. Repackage the jukebox in the same way it was received
Your service representative can provide assistance or advise you on how to best
repackage and ship your jukebox
1-22 Chapter 1