Changing The Administration Menu Password - HP 220mx User Manual

CAUTION
Operating the Jukebox

Changing the Administration Menu Password

Changing the Administration Menu Password
>
READY ADMIN *
1. Follow the steps on the previous page to enter your password (or the default,
factory-set password 000 000 000).
2. TEST * displays. Press
3. Press or
NEXT PREV
4. NEW 000 000 000 displays and the first set of three zeros flashes. Press
or until the new number you wish to assign to the first part of the
NEXT PREV
password displays and then press
5. Press or
NEXT PREV
of the password displays and then press
flashes.
6. Press or
NEXT PREV
the password displays and then press
7. PASSWORD CHANGED displays. Press
Turning off the jukebox in the next step could cause data loss if not done correctly.
Do not turn off power to the jukebox until you are sure the SCSI bus is inactive.
Removing power from a SCSI device when the bus is active can result in data loss
and/or indeterminate bus states. Check your host system manuals for information
about checking the SCSI bus status. If your computer is connected to a LAN, be sure
to check with your system administrator before turning off power to the jukebox.
8. Turn the jukebox OFF, then ON to save the password to the jukebox flash ROM.
3-14
>
PSWD 000 000 000
until CONFIG * displays, and then press
NEXT
or until NEW PASSWORD displays and then press
. The second set of three zeros flashes.
ENTER
until the new number you wish to assign to the second part
ENTER
until the new number you wish to assign to the third part of
ENTER
CANCEL
>CONFIG *
. The third set of three zeros
.
three times to return to READY
.
ENTER
.
ENTER
Chapter 3