Running An Internal Test - HP 220mx User Manual

CAUTION
NOTE
Operating the Jukebox

Running an Internal Test

Running an Internal Test
>
READY ADMIN *
The optical jukebox can run self-diagnostic tests. See the Caution note below.
Some of the internal diagnostic tests of this jukebox can corrupt your file system if
not properly completed (for example, disks can be placed in unexpected locations).
In almost all cases, these tests should be run only by authorized service personnel.
Service, however, may request that you run specific tests to provide information
before they come to your site. The descriptions of these tests are included in this
manual only for your information.
Instructions for running internal tests are included in this guide to help you run tests
if requested by service. There is a possibility you may run one test as a result of
troubleshooting; this test is "INIT ELEM STATUS."
Start with READY in the display.
1. Press until ADMIN * displays.
NEXT
2. Enter the administration password.
Instructions for entering this password are in "Entering the Administration
Menu Password" previously in this chapter.
3. TEST * displays. Press
4. Press until the name of the test you wish to run displays and then press
NEXT
to start the test.
ENTER
You may press
CANCEL
current test loop completes.
3-28
>
TEST *
.
ENTER
at any time to abort a test. A delay may occur while the
Chapter 3