HP 220mx User Manual page 79

Problem
Disk eject attempted but
RESERVED displays.
Disk eject attempted but
empty and then EJECT *
displays.
Disk eject attempted but
TRANSPORT FULL
displays.
Disk eject attempted but
SOURCE NOW EMPTY
displays.
Disk eject attempted but
MAILSLOT FULL
displays.
You want to stop a test
that is running.
*Ensure that the SCSI bus is inactive before removing power to the jukebox.
Removing power to a device on an active SCSI bus can cause data loss and/or
problems with the SCSI interface.
Chapter 3
What to do
The jukebox application software reserved the
element for its use or a security configuration was set
to prevent disk ejection.
• If appropriate, change this setting See "Setting an
Operating Configuration" in this chapter. The
current administration password is required.
This is not an error. There are no disks in the
jukebox.
The disk transport mechanism already contains a
disk.
• Refer to your host and application documentation
for recovery procedures. If no procedures are
available, call your service representative.
The application software moved the disk from the
slot you chose before your eject command executed.
Press . You may have to wait for the
•
CANCEL
application to replace the disk into the slot
before attempting another eject.
A disk is in the mailslot.
• Remove the disk from the mailslot.
Select EJECT *, select the slot you want the
disk ejected from again, and eject the disk.
Press . The current test loop continues until
CANCEL
finished, then the test stops.
Operating the Jukebox
Troubleshooting
3-39