Setting The Scsi Ids; Setting The Lun Mode - HP 220mx User Manual

Setting the SCSI IDs

NOTE If you are unfamiliar with basic SCSI addressing or LUN addressing, refer to
Appendix B.
First, determine if you are using basic SCSI addressing or logical unit numbering
(LUN). Setting the LUN mode is explained below.
Next, either view the current SCSI IDs or proceed directly to setting IDs. The next
two procedures are "Viewing the Current SCSI IDs" and "Changing the Current
SCSI IDs."
Tables showing default SCSI IDs for basic SCSI addressing and LUN addressing are
in Appendix B.

Setting the LUN Mode

READY
NOTE
If you are unfamiliar with basic SCSI addressing or LUN addressing, refer to
Appendix B.
NOTE Check your host system documentation and jukebox application software
documentation to verify that the use of LUNs is supported.
Start with READY in the display.
1. Press
2. Enter the administration password.
3. Press
4. VIEW ID'S displays. Press
5. Press
Chapter 3
>
ADMIN *
until ADMIN * displays and then press
NEXT
Instructions for entering this password are in "Entering the Administration
Menu Password" previously in this chapter.
until SCSI ID'S displays, and then press
NEXT
then press . LUN MODE ON or LUN MODE OFF displays and ON or OFF
ENTER
is blinking.
to change the setting and then press
NEXT
and then TURNED OFF or TURNED ON display briefly. Then SCSI ID'S
displays.
> >
SCSI ID'S *
until CHOOSE LUN MODE * displays and
NEXT
ENTER
Operating the Jukebox
Setting the SCSI IDs
CHOOSE LUN MODE *
.
ENTER
.
ENTER
. WAIT FOR UPDATE
3-15