Changing Scsi Ids; Changing The Jukebox Controller Id - HP Surestore 80ex - Optical Jukebox User Manual

NOTE
NOTE
Operating the Jukebox

Changing SCSI IDs

Changing SCSI IDs
The jukebox controller uses two SCSI IDs if your jukebox has one drive and three
IDs if your jukebox has two drives. The jukebox controller is assigned one ID and
one ID is assigned to each disk drive.
The default SCSI IDs are as follows
• jukebox controller = 3
• disk drive 1 (lower drive) = 4
• disk drive 2 (upper drive in a two-drive model) = 5
If you are already using one of these IDs for your computer or another SCSI
peripheral device, follow the directions in one of the next two sections to change
either the jukebox controller or a drive ID.

Changing the Jukebox Controller ID

Start with READY in the display.
1. Press until SCSI ID * displays.
NEXT
2. Press . AC ID * displays. ("AC" is the "jukebox controller.")
ENTER
3. Press . AC ID 3 displays.
ENTER
4. Press or
NEXT PREV
5. Press . SET # (# is a number from 0-7) displays briefly and then AC ID
ENTER
* displays again. The ID you chose is now set.
6. Press two times to return to the READY state.
CANCEL
CONFLICT displays if you attempt to set the jukebox controller and a drive to the
same ID. Repeat the procedure and reset one of the IDs to another, non-conflicting
ID.
After you change an ID you may have to restart your host computer for the new ID
to be recognized.
3-18
until the ID you want displays.
Chapter 3