Configuring Trunk Mode Vlan Membership; Configuring Hybrid Mode Vlan Membership - Mellanox Technologies Mellanox SX1018 User Manual

Enter the interface context. Run:
Step 5.
switch (config) # interface ethernet 1/36
switch (config interface ethernet 1/36) #
From within the interface context, configure the interface mode to Access. Run:
Step 6.
switch (config interface ethernet 1/36) # switchport mode hybrid
switch (config interface ethernet 1/36) #
From within the interface context, configure the Access VLAN membership. Run:
Step 7.
switch (config interface ethernet 1/36) # switchport hybrid vlan 6
switch (config interface ethernet 1/36) #
Change to config mode again. Run:
Step 8.
switch (config interface ethernet 1/36) # exit
switch (config) #
5.3.3

Configuring Trunk Mode VLAN Membership

 To configure Trunk mode VLAN membership:
Log in as admin.
Step 1.
Enter config mode. Run:
Step 2.
switch > enable
switch # configure terminal
Create a VLAN. Run:
Step 3.
switch (config) # vlan 10
switch (config vlan 10) #
Change back to config mode. Run:
Step 4.
switch (config vlan 10) # exit
switch (config) #
Enter the interface context. Run:
Step 5.
switch [standalone: master] (config) # interface ethernet 1/35
switch [standalone: master] (config interface ethernet 1/35) #
From within the interface context, configure the interface mode to Trunk. Run:
Step 6.
switch [standalone: master] (config interface ethernet 1/35) # switchport mode trunk
switch [standalone: master] (config interface ethernet 1/35) #
5.3.4

Configuring Hybrid Mode VLAN Membership

 To configure Hybrid mode VLAN membership:
Log in as admin.
Step 1.
Enter config mode. Run:
Step 2.
switch > enable
switch # configure terminal
Create a VLAN. Run:
Step 3.
switch (config) # vlan 10
switch (config vlan 10) #
Mellanox Technologies Confidential
Mellanox Technologies 69
Rev 1.6.9