Mellanox Technologies Mellanox SX1018 User Manual page 14

Table 7 - Configuration Wizard Session - IP Configuration by DHCP (Sheet 3 of 3)
Wizard Session Display (Example)
You have entered the following information:
1. Hostname: <switch name>
2. Use DHCP on mgmt0 interface: yes
3. Enable IPv6: yes
4. Enable IPv6 autoconfig (SLAAC) on mgmt0
interface: yes
5. Admin password (Enter to leave unchanged):
(CHANGED)
To change an answer, enter the step number to
return to.
Otherwise hit <enter> to save changes and exit.
Choice: <Enter>
Configuration changes saved.
To return to the wizard from the CLI, enter the
"configuration jump-start" command from
configuration mode. Launching CLI...
<switch name> [standalone: master] >
The wizard displays a summary of your
choices and then asks you to confirm the
choices or to re-edit them.
Either press <Enter> to save changes and exit,
or enter the configuration step number that you
wish to return to.
Note:
To run the command "configuration jump-
start" you must be in Config mode.
Mellanox Technologies Confidential
Comments
Mellanox Technologies
Rev 1.6.9
14