Mellanox Technologies Mellanox SX1018 User Manual page 83

The system on the receiving end of the analyzer port must be set to handle the egress traffic. If it
is not, it might discard it and indicate this in its statistics (packet too long).
5.10.1.3 Header Format
Ingress traffic from the source interface can be manipulated in several ways depending on the
network layout using the command header-format.
If the analyzer system is directly connected to the destination interface, then the only parameters
that can be configured on the port are the MTU, speed and port based flow control. Priority flow
control is not supported is this case. However, if the analyzer system is indirectly connected to
the destination interface, there are two options for switching the mirrored data to the analyzer
system:
• A VLAN tag may be added to the Ethernet header of the mirrored traffic
• An Ethernet header can be added with include a new destination address and VLAN tag
It must be taken into account that adding headers increases packet size.
Source Frame
Type/
DA SA Data
Len
Source Frame
Type/
DA SA Data
Len
Source Frame
Type/
DA SA Data
Len
Source Frame
Type/
DA SA Data
Len
5.10.1.4 Congestion Control
The destination ports might receive pause frames that lead to congestion in the switch port. In
addition, too much traffic directed to the analyzer port (for example 40GbE mirror port is
directed into 10G analyzer port) might also lead to congestion.
In case of congestion:
• When best effort mode is enabled on the analyzer port, SwitchX drops excessive traffic
headed to the analyzer port using tail drop mechanism, however, the regular data (mir-
rored data heading to its original port) does not suffer from a delay or drops due to the
analyzer port congestion.
• When the best effort mode on the analyzer port is disabled, the SwitchX does not drop
the excessive traffic. This might lead to buffer exhaustion and data path packet loss.
Figure 12: Header Format Options
Mirror Frame
local
DA SA
Mirror Frame
add‐vlan
DA SA
Mirror Frame
add‐ethernet‐header
DA SA
Mirror Frame
add‐ethernet‐header
(+vlan)
DA SA
Mellanox Technologies Confidential
Type/
Data
Len
Type/
VLAN Data
0x8100
Len
Type/
DA SA
0x8949
Len
VLAN DA
0x8100 0x8949
Mellanox Technologies
Rev 1.6.9
Data
Type/
SA Data
Len
83