Mellanox Technologies Mellanox SX1018 User Manual page 78

Log in as admin.
Step 1.
Enter config mode. Run:
Step 2.
switch > enable
switch # configure terminal
Run the command
Step 3.
switch (config) # no dcb ets enable
 To configure the WRR bandwidth percentage:
Log in as admin.
Step 1.
Enter config mode. Run:
Step 2.
switch > enable
switch # configure terminal
Make sure ETS feature is enabled. Run:
Step 3.
switch (config) # dcb ets enable
Choose the WRR bandwidth rate and distribution.
Step 4.
By default the WRR distribution function is equal 25% per TC. Changing the WRR bandwidth
rate will cause a change in the distribution function, for example if you wish to schedule more
traffic on TC-0, TC-1, TC-2 while reducing the amount of traffic sent on TC-3, run the com-
mand dcb ets tc bandwidth.
switch (config) # dcb ets tc bandwidth 30 30 30 10
# show dcb ets
ETS enabled
TC Bandwidth
--------------------------
0 30%
1 30%
2 30%
3 10%
Number of Traffic Class: 4
switch (config) #
Traffic class priorities are <0-3>, where 0 is the lowest and 3 is the highest.
The sum of all traffic class bandwidth value (in percentage) should be 100, otherwise
the command will fail.
.
dcb ets disable
Mellanox Technologies Confidential
Mellanox Technologies 78
Rev 1.6.9