Using The Device As An Ftp Client; Establishing An Ftp Connection - HP 6125XLG Configuration Manual

[Sysname] quit
3. Perform FTP operations from the FTP client:
# Log in to the FTP server at 1.1.1.1 using the username abc and password 123456.
c:\> ftp 1.1.1.1
Connected to 1.1.1.1. (1.1.1.1)
220 FTP service ready.
User(1.1.1.1:(none)):abc
331 Password required for abc.
Password:
230 User logged in.
# Use the ASCII mode to download the configuration file config.cfg from the FTP server to the PC
for backup.
ftp> ascii
200 TYPE is now ASCII
ftp> get config.cfg back-config.cfg
# Use the binary mode to upload the file temp.bin from the PC to the Flash root directory of the
master.
ftp> binary
200 TYPE is now 8-bit binary
ftp> put temp.bin
# Exit FTP.
ftp> bye

Using the device as an FTP client

Perform the configuration in this section to use the device as an FTP client.

Establishing an FTP connection

To access the FTP server, you must establish a connection from the FTP client to the FTP server.
To establish an IPv4 FTP connection:
Step
1. Enter system view.
2. (Optional.) Specify a source
IP address for outgoing FTP
packets.
3. Return to user view.
Command
system-view
ftp client source { interface interface-type
interface-number | ip source-ip-address }
quit
66
Remarks
N/A
By default, no source IP
address is specified, and the
primary IP address of the
output interface is used as the
source IP address.
N/A