Using The Device As An Ftp Client; Establishing An Ftp Connection - HP 5130 EI series Configuration Manual

Using the device as an FTP client

Establishing an FTP connection

To access the FTP server, you must establish a connection from the FTP client to the FTP server.
To establish an IPv4 FTP connection:
Step
1. Enter system view.
2. (Optional.) Specify a source
IP address for outgoing FTP
packets.
3. Return to user view.
4. Log in to the FTP server.
To establish an IPv6 FTP connection:
Step
1. Enter system view.
2. (Optional.) Specify the
source IPv6 address for FTP
packets sent by the FTP client.
3. Return to user view.
Command
system-view
ftp client source { interface interface-type
interface-number | ip source-ip-address }
quit
•
(Method 1.) Log in to the FTP server
from user view:
ftp ftp-server [ service-port ][ dscp
dscp-value | source { interface
{ interface-name | interface-type
interface-number } | ip
source-ip-address } ] *
•
(Method 2.) Log in to the FTP server
from FTP client view:
a. ftp
open server-address
b.
[ service-port ]
Command
system-view
ftp client ipv6 source { interface
interface-type interface-number |
ipv6 source-ipv6-address }
quit
77
Remarks
N/A
By default, no source IP
address is specified, and the
primary IP address of the
output interface is used as the
source IP address.
N/A
The source IP address
specified in the ftp command
takes precedence over the
one set by the ftp client source
command.
Remarks
N/A
By default, no source IPv6 address
is specified. The source address is
automatically selected as defined
in RFC 3484.
N/A