Configuring User Role Authentication; Obtaining Temporary User Role Authorization; Displaying Rbac Settings - HP 6125XLG Configuration Manual

Configuring user role authentication

Step
1. Enter system view.
2. Set an authentication
mode.
Set a local
3.
authentication
password for
switching to a user
role.

Obtaining temporary user role authorization

VTY users must pass authentication before they can use a user role that is not included in the user account
they are logged in with.
Perform the following task in user view:
Task
Obtain the temporary
authorization to use a
user role.

Displaying RBAC settings

Execute display commands in any view.
Task
Display user role information.
Display user role feature
information.
Display user role feature group
information.
Command
system-view
super authentication-mode { local |
scheme } *
•
In non-FIPS mode:
super password [ role rolename ]
[ { hash | simple } password ]
•
In FIPS mode:
super password [ role rolename ]
Command
super [ rolename ]
Command
display role [ name role-name ]
display role feature [ name feature-name | verbose ]
display role feature-group [ name feature-group-name ] [ verbose ]
52
Remarks
N/A
By default, local-only authentication
applies.
Use this step for local password
authentication.
By default, no password is
configured.
If you do not specify the role
rolename option, the command sets
the password for network-admin.
Remarks
The operation fails after three consecutive unsuccessful
password attempts.
Make sure the current user role has the permission to
execute the super command.