Managing The Device; Configuring The Device Name; Setting The System Time - HP 6125XLG Configuration Manual

Managing the device

This chapter describes how to monitor the operating status of the device, configure the running
parameters (such as the device name, system time, and the temperature alarm thresholds), and reboot
the device.
You can perform the configuration tasks in this chapter in any order.

Configuring the device name

A device name, or "hostname," identifies a device in a network and is used as the user view prompt at
the CLI. For example, if the device name is Sysname, the user view prompt is <Sysname>.
To configure the device name:
Step
1. Enter system view.
2. Configure the device name.

Setting the system time

The system time is determined by the UTC time, local time zone, and daylight saving time. You can use
the display clock command to view the system time.
A correct system time setting is essential to network management and communication. Before you run the
device on the network, set the system time correctly or configure NTP to synchronize the system time to a
trusted time source. If you perform both configuration tasks, the device uses the system time of the trusted
time source. For more information about NTP, see Network Management and Monitoring Configuration
Guide.
Powering off or rebooting an HP 6125XLG switch does not affect the system time.
To set the system time:
Step
1. Set the UTC time.
2. Enter system view.
3. Set the local time zone.
4. Set the daylight saving time
Command
system-view
sysname sysname
Command
clock datetime time date
system-view
clock timezone zone-name { add |
minus } zone-offset
clock summer-time name start-time
start-date end-time end-date
add-time
98
Remarks
N/A
The default device name is HP.
Remarks
Execute this command in user
view.
The default UTC time is 00:00:00
on 01/01/2011.
N/A
The default local time zone is the
UTC time zone.
By default, daylight saving time is
disabled.