Viewing The Current Instrumentation Monitor Configuration - HP ProCurve 6120G/XG Manual

Viewing the Current Instrumentation Monitor
Configuration
The show instrumentation monitor configuration command displays the config­
ured thresholds for monitored parameters.
ProCurve# show instrumentation monitor configuration
PARAMETER
------------------------- ---------------
mac-address-count
ip-address-count
system-resource-usage
system-delay
mac-moves/min
learn-discards/min
ip-port-scans/min
arp-requests/min
login-failures/min
port-auth-failures/min
SNMP trap generation for alerts: enabled
Instrumentation monitoring log : enabled
Figure 10-10. Viewing the Instrumentation Monitor Configuration
An alternate method of determining the current Instrumentation Monitor
configuration is to use the show run command. However, the show run
command output does not display the threshold values for each limit set.
LIMIT
1000 (med)
1000 (med)
50 (med)
5 (high)
100 (med)
100 (med)
10 (med)
100 (low)
10 (med)
10 (med)
Configuring Advanced Threat Protection
Using the Instrumentation Monitor
10-37