Viewing The Current Instrumentation Monitor Configuration - HP ProCurve Switch 6120G/XG Manual
Hp procurve series 6120 blade switches access security guide
Hide thumbs
Also See for ProCurve Switch 6120G/XG:
- Configuration manual (662 pages) ,
- Manual (606 pages) ,
- Management manual (222 pages)
Table of Contents
Advertisement
ProCurve# show instrumentation monitor configuration
PARAMETER
------------------------- ---------------
mac-address-count
ip-address-count
system-resource-usage
system-delay
mac-moves/min
learn-discards/min
ip-port-scans/min
arp-requests/min
login-failures/min
port-auth-failures/min
SNMP trap generation for alerts: enabled
Instrumentation monitoring log : enabled
Figure 8-10. Viewing the Instrumentation Monitor Configuration
Viewing the Current Instrumentation Monitor
Configuration
The show instrumentation monitor configuration command displays the config-
ured thresholds for monitored parameters.
LIMIT
1000 (med)
1000 (med)
50 (med)
5 (high)
100 (med)
100 (med)
10 (med)
100 (low)
10 (med)
10 (med)
An alternate method of determining the current Instrumentation Monitor
configuration is to use the show run command. However, the show run
command output does not display the threshold values for each limit set.
Configuring Advanced Threat Protection
Using the Instrumentation Monitor
8-37
Hide quick links:
Advertisement
Table of Contents
