Display All Acls And Their Assignments In The Switch Startup-Config File And Running-Config File; Editing Acls And Creating An Acl Offline; Using The Cli To Edit Acls - HP ProCurve 6120G/XG Manual

ProCurve(config)# show access-list resources
Policy Engine Resource Usage
Group
------------------------+------------+------------+------------+
QoS
CLI-ACL
IDM-ACL
Free
Figure 9-23. Example of a Show Access-List Resources Command Output
Display All ACLs and Their Assignments in
the Switch Startup-Config File and Running-Config File
The show config and show running commands include in their listings any
configured ACLs and any ACL assignments to interfaces. Refer to figure 9-13
(page 9-43) and figure 9-14 (page 9-44) for examples. Remember that show
config lists the startup-config file and show running lists the running-config file.
Editing ACLs and Creating an ACL
Offline
Earlier sections of this chapter describe how to use the CLI to create an ACL.
Beginning with "Using the CLI To Edit ACLs", below, describes how to use the
CLI to edit existing ACLs. However, you can also create or edit an ACL offline,
then use a TFTP server to upload the ACL as a command file. The offline
method (page 9-64) provides a useful alternative to using the CLI for creating
or editing large ACLs.

Using the CLI To Edit ACLs

The switch applies individual ACEs in the order in which they occur in an ACL.
You can use the CLI to delete individual ACEs from anywhere in an ACL and
to append new ACEs to the end of an ACL. However, the CLI method does not
allow you to insert a new ACE between two existing ACEs.
Rules
Allocated
| 0 |
| 0 |
| 256 |
| 128 |
IPv4 Access Control Lists (ACLs)

Editing ACLs and Creating an ACL Offline

Rules Group
Used Number
0 | 1 |
0 | 2 |
126 | 3 |
9-61