Where To Place The Bipap S/T - Respironics BiPAP S/T User Manual

18
3. Attach the filter cap as shown in Figure 5–2. Position the cap so that
the small opening on the cap is facing down. Insert the caps bottom
tabs into the openings below the filter area. Snap the cap into place.
NOTE: The filter cap should be installed with the air inlet opening at
the bottom.
See Chapter 9 to clean or replace the filters.

5.2 Where to Place the BiPAP S/T

Place the device on its base somewhere within easy reach of where
you will use it. Make sure that the air inlet on the rear of the unit is not
blocked. Place the unit on a hard, flat surface. If you block the air flow
around the unit, the device may not work properly.
WARNING: Position the humidifier so the water level is lower than
you, and the humidifier is on the same level or lower than
the device. See the humidifier instructions for complete
setup information.
User Manual
Figure 5–2 Attaching the Filter Cap