A computer on any LAN segment should be able to connect to the Internet or share files
and printers with computers or servers connected to any of the three WLAN segments.
Click Apply to save your settings.
8.
You can extend repeating by adding up to two additional access points configured in repeater
mode. However, since repeater configurations communicate in half-duplex mode, the
bandwidth decreases as you add repeaters to the network.
Client Mode
In client mode the access point operates as a client bridge only and sends traffic to the
selected remote AP or peer device.
To configure the access point for client mode:
Select Configuration > Wireless Bridge > Bridging and Repeating. The Bridging and
1.
Repeating screen displays.
Select the Enable Wireless Bridging and Repeating check box. This allows you to select
2.
a bridging mode.
Select Client. You can now enable the MAC clone feature. The default is Disable. If you
3.
enable the MAC clone feature, enter the MAC clone address.
Click Apply.
4.
ProSafe Wireless-N Access Point WNAP210
Advanced Configuration
57