Point-To-Multi-Point Wireless Bridge - NETGEAR WNAP210 User Manual

Configure the other access point (AP 2) on LAN Segment 2 in point-to-point bridge mode.
5.
AP 1 needs to have AP 2's MAC address in its Remote MAC Address field, and AP 2
needs to have AP 1's MAC address in its Remote MAC Address field.
Configure and verify the following parameters for both access points:
6.
Verify that both access points are configured to operate in the same LAN network
•
address range as the LAN devices.
Both use the same ESSID, channel, authentication mode, if any, and security
•
settings.
Verify connectivity across LAN 1 and LAN 2.
7.
A computer on either LAN segment should be able to connect to the Internet or share files
and printers of any other computers or servers connected to LAN Segment 1 or LAN
Segment 2.
Click Apply to save your settings.
8.

Point-to-Multi-Point Wireless Bridge

AP 1
Router
LAN Segment 1
Figure 4. Point-to-multi-point-bridge mode
ProSafe Wireless-N Access Point WNAP210
APs in point-to-multi-point bridge mode
AP 2
LAN Segment 2
Advanced Configuration
54
AP 3
Hub or switch
Hub or switch
LAN Segment 3