Factory Default Settings - NETGEAR WNAP210 User Manual

Factory Default Settings

You can use the Restore Factory Settings button on the rear panel to reset all settings to their
factory defaults. This is called a hard reset. Pressing this button for a shorter period of time
simply causes your device to reboot.
To perform a hard reset:
Use something with a small point, such as a pen, to press the Restore Factory Settings
1.
button in and hold it in for at least 5 seconds (until the Test LED blinks rapidly).
Release the button.
2.
Your device returns to the factory configuration settings shown in the following table.
Table 5. Access point default configuration settings
Feature
Login URL
User name (case-sensitive)
Login password (case-sensitive)
Static IP address
Ethernet MAC address
Port speed
LAN IP
Subnet mask
Gateway address
DHCP client
Time zone
Time zone adjusted for daylight saving
time
SNMP
ProSafe Wireless-N Access Point WNAP210
Default setting
192.168.0.236
admin
password
192.168.0.210
See bottom label.
10/100/1000
192.168.0.236
255.255.255.0
0.0.0.0
Disabled
USA-Pacific
Disabled
Enabled, but trap forwarding disabled
Supplemental Information
63
Restore
Factory
Settings