Point-to-Point Bridge
AP 1
LAN Segment 1
Figure 3. Point-to-point bridge mode
To configure a point-to-point bridge:
Select Configuration > Wireless Bridge > Bridging and Repeating. The Bridging and
1.
Repeating screen displays.
Select the Enable Wireless Bridging and Repeating check box. This allows you to select
2.
a bridging mode.
Select Wireless Point-to-Point Bridge, and click Apply.
3.
Configure the first access point (AP 1) on LAN Segment 1 in point-to-point bridge mode.
4.
ProSafe Wireless-N Access Point WNAP210
APs in point-to-point bridge mode
Router
Advanced Configuration
53
AP 2
Hub or switch
LAN Segment 2