To set up an SNMP management interface:
Select Maintenance > Remote Management > SNMP. The SNMP screen displays, as
1.
shown in the following figure:
Enter the following information in the SNMP fields:
2.
SNMP. Enable SNMP to allow the SNMP network management software, such as HP
•
OpenView, to manage the wireless access point through SNMPv1/v2 protocol.
Read-Only Community Name. The community string to allow the SNMP manager to
•
read the wireless access point's MIB objects. The default is Public.
Read-Write Community Name. The community string to allow the SNMP manager
•
to read and write the wireless access point's MIB objects. The default is Private.
Trap Community Name. The community string to allow the SNMP manager to send
•
traps. The default is Trap.
IP Address to Receive Traps. The IP address of the SNMP manager to receive traps
•
sent from the wireless access point. The default is 0.0.0.0.
Click Apply.
3.
ProSafe Wireless-N Access Point WNAP210
Management
33