NETGEAR WNAP210 User Manual page 26

Leave Wireless Client Security Separation set to No (it is disabled by default). If this feature
7.
is enabled, the associated wireless clients will not be able to communicate with each other.
If the hubs and switches on your LAN support the VLAN (802.1Q) standard and this feature
8.
has been enabled, the default VLAN ID for WNAP210 is associated with each profile. The
default profile VLAN ID has to match the IDs used by other network devices.
Click Apply to save your security profile settings.
9.
Click Back. Your new settings display in the Security Profiles table identified by the name of
10.
the profile. A VLAN ID is also assigned to your profile.
Security profiles that share the same type of network authentication
Note:
need not share the same passphrase or keys. Security profiles that
use WEP have to share the same four keys, but they do not need to
use the same default key.

To enable your security profile:
Select the Enable check box in the column next to your profile.
1.
Click Apply. Your security profile is enabled. If you enabled VLAN 802.1Q, your VLAN profile
2.
is enabled. (See
802.1Q.)
WPA2, WPA2 & WPA, or WPA with RADIUS
Make sure that your wireless clients support WPA 2 or WPA with RADIUS. Note that you can
set up the access point to work with a combination of clients, some of which use WPA2 and
some of which use WPA.

To configure WPA2 or WPA with RADIUS:
Select Configuration > Security > Advanced > RADIUS Server Settings. The
1.
RADIUS Server Settings screen displays.
Enter the RADIUS server settings as shown in
2.
click Apply.
Select Configuration > Security > Profile Settings. The profile settings you selected
3.
display.
ProSafe Wireless-N Access Point WNAP210
on page 13 for information about how to enable VLAN
Set Basic IP Options
Installation and Configuration
RADIUS Server Settings
26
on page 24, and