Oneida Air Systems Dust Deputy AXD001004 Owner's Manual page 12

VI. Assembly Instructions for Deluxe Dust Deputy® Kit
If hoses are not tight on the inlet, or keep
pulling off, use the included Hose Reten-
tion Ring or the included clamp or both as
shown below.
Hose Retention Ring
11
Make sure larger
diameter hoses are
pushed up so they fit
tightly over the inlet
Hose Clamp
Dust Deputy® Owner's Manual © 2010
VII. Assembly Instructions for Ultimate Dust Deputy®
1. With a Phillips head screwdriver, attach
the two rubber latches, one on either side of
the dust collection box using the (4) 10 x 32
x 1" machine screws included
in the hardware pack. Make sure
that the handle of the latch curves
downward when attached or when
in the up position it points out.
2. Take the provided length of gasket, peel
It is very important that there are no
gaps in the gasket where the ends meet.
Make sure they are butted together!
Gasket
3. Put Gasket on box top making sure gasket holes
4. With a Phillips head screwdriver, attach
Dust Deputy® Owner's Manual © 2010
the protective backing off of the gasket
and carefully place the gasket flat around
the underside of the box top as shown,
not on the side of the inside lid.
line up with bolt holes in top.
the Cyclone with the (6) provided 1/4"x 20
x 3/4" bolts. Tighten in a star pattern as
shown. Do NOT over tighten.
Point inlet at
either latch.
Star Bolt Pattern
NO
YES
12