Oneida Air Systems Dust Deputy AXD001004 Owner's Manual page 11

VII. Assembly Instructions for Ultimate Dust Deputy®
5. Pull up latch so hole in latch goes over the pin /
6. Attach hose from vacuum to the top of the Dust
7. If you are using the Festool hose, attach included
adapter, white end first on the cyclone inlet as shown,
then connect hose to adapter.
You can put the hoses in the box
and turn the top upside down and
latch the top down to transport the
Dust Deputy® to a job site so the
cyclone is protected.
13
boss on Dust Box top.
Deputy® cyclone outlet.
Elbow
An optional Elbow can be used on the outlet
to reduce stress on the Dust Deputy® top
during use.
Dust Deputy® Owner's Manual © 2010
VI. Assembly Instructions for Deluxe Dust Deputy® Kit
The Dust Deputy® is made of static dissipating
1.) Place supplied gasket on plastic drum top, lining up
holes in gasket with holes in lid.
2.) Install metal tape then place bolt through washer
then put bolt through hole in base of cyclone. Secure
with nut underneath.
For additional static
reduction, install metal
tape as shown.
Cover bolt hole and use the
bolt for the grounding wire
anchor.
Bolt
Wire
Nut
Gasket
For added grounding, attach wire to bolt between bolt head
and washer, then attach another washer to end of wire. Wire
must be long enough for washer to lie flat on floor.
This hardware not provided.
Dust Deputy® Owner's Manual © 2010
plastic.
3.) Snap lid tightly on drum and
you're ready to go.
A
4.) Attach provided hose from shop
vacuum to top outlet on cyclone (A).
Use shop vacuum hose to attach to
tools. (B).
Use included elbow on the shop vacuum
inlet or on the outlet of the cyclone.
(Ring Terminal Recommended)
Elbow
Washer
Base
Washer
Floor
B
10