Horizontal Scan Connectors; Vertical Scan Connectors; Scan Connector Settings - Barco R9040014 Installation Manual

Installation setup

Horizontal Scan connectors

When changing the horizontal scan, insure that all three connectors are set in the same position.
The configuration of each connector is depending on its orientation i.e. on the position of the strap (grey wire).

Vertical Scan connectors

When changing the vertical scan, insure that all three connectors are set in the same position.
The configuration of each connector is depending on its orientation i.e. on the position of the (grey wire) strap A (Image 1) .
$
Image 1

Scan connector settings

The position of the scan connectors for the different mounting configurations can be summarized as follows:
Configuration1: Rear/Table
J152 J252
Configuration2: Front/Ceiling
J152 J252
Configuration3: Front/Table
J152
J252
Configuration4: Rear/Ceiling
J152 J252
J151: Horizontal Red Scan Connector
J251: Horizontal Green Scan Connector
J351: Horizontal Bleu Scan Connector
J152: Vertical Red Scan Connector
J252: Vertical Green Scan Connector
J352: Vertical Bleu Scan Connector
After setting the scan connectors, close the metal protection plate and secure it with the retaining screws.Close the top cover and
lock it with the locking screw.
4-4
J352
J352
J352
J352
5976257 BARCOREALITY909 16032001