Setting Up Wps Through The Push Button Method - 2Wire HomePortal 3801HGV User Manual

HomePortal 3801HGV Gateway User Guide
4. Enter a 4 or 8 digit PIN in Enter the PIN text box. The PIN method requires a 4- or 8-digit
PIN.
5. Click Set WPS. This saves the PIN configuration changes done for WPS.

Setting Up WPS through the Push Button Method

To set up WPS through the PIN method:
1. Navigate to Settings > LAN > Wireless. The Wireless page appears.
2. In the Wi-Fi Protected Setup section, enable the WPS by selecting the Wi-Fi Protected
Setup check box.
3. Select Push Button from the drop-down list.
4. Locate and push the WPS button found at the front panel of the device. The gateway
provides a push button on the front panel to enable the synchronization between the AP
and the client. You do not have to connect any devices to the gateway to enable it - simply
push the button on the gateway followed by pushing the button on the client device.
5. Click Set WPS. This saves the Push Button configuration changes done for WPS.
Configuring Wi-Fi Protected Setup
Configuring LAN Devices
63