Resetting Statistics On Status Page; Configuring Bridge Mode - 2Wire HomePortal 3801HGV User Manual

HomePortal 3801HGV Gateway User Guide
Parameter
Uncorrectable Blocks
DSL Unavailable Seconds

Resetting Statistics on Status Page

After rectifying the issues that are seen in different sections of the Status page, you must reset
this page to determine if the issue is resolved. To do this, click the Reset Statistics button at the
bottom of the Status page.

Configuring Bridge Mode

Objective
To configure bridge mode.
Bridge mode is used to configure devices on the LAN with a broadband IP . When the gateway is into
bridge mode you can use a supplementary network or a third party router to handle the traffic. The
gateway will only function as a direct connection to the phone line.
Note
By default, the gateway is configured in the routing mode. When routing is disabled, the
NAT and the DHCP server are also disabled. Confirm with the ISP that the WAN protocol is
compatible with bridging mode.
Configuring Bridge Mode
Description
Number of uncorrected DSL superframes that have data errors detected.
Number of times the ISP connection was established since the statistics were
last reset, and the elapsed time since the last establishment.
Configuring Broadband Settings
40