Rnav Approach Procedures - Garmin GTN 725 Pilot's Manual

NOTE: If you attempt to intercept the approach course at a distance less
Foreword
than 2.0 NM from the FAF, the GTN 7XX does not automatically switch
the CDI to VLOC. In this case, touch the CDI key to manually switch from
Getting
Started
GPS to VLOC.
Audio &
The automatic switch from GPS to VLOC is not immediate, but instead occurs
Xpdr Ctrl
gradually to prevent abrupt CDI changes when coupled to an autopilot. The CDI
Com/Nav
selection can also be changed manually by touching the CDI key.
6.11
FPL
The GTN 7XX allows for flying LNAV, LNAV/VNAV, LNAV + V, LP, and LPV
Direct-To
approaches according to the published chart.
Proc
Phase of flight
Annunciation
Charts
L/VNAV
Wpt Info
LNAV
Map
LNAV + V
Traffic
Terrain
Weather
Nearest
Services/
Music
LPV
Utilities
System
LP
Messages
Symbols
Appendix
6-18
Index

RNAV Approach Procedures

Lateral Navigation/Vertical Navigation. RNAV non-
precision approach with vertical guidance.
Lateral Navigation. RNAV non-precision approach.
Lateral Navigation with Advisory Vertical
Guidance. RNAV non-precision LNAV approach
with advisory vertical guidance. The glidepath
is typically denoted by a light dashed line on
the vertical profile (Jeppeson only) with an
associated glidepath angle (usually in the 3.00
degree range) and is provided to assist the pilot
in maintaining a constant vertical glidepath,
similar to an ILS glideslope.
Localizer Performance with Vertical guidance
(LPV) approach.
RNAV precision approach.
LP indicates Localizer Performance with no
vertical guidance.
Table 6-2 RNAV Approach Annunciations
Garmin GTN 725/750 Pilot's Guide
Description Minimums
Published LNAV/
VNAV minimums.
Published LNAV
minimums.
Published LNAV
minimums.
Published LPV
minimums.
Published LP
minimums.
190-01007-03 Rev. D