Com/Nav; Waypoint Location Based On Two Radials - Garmin GTN 725 Pilot's Manual

Even when the hemisphere values are highlighted, touching the
numeric keys will always place the cursor at the first numeric
value. The Large knob may also be used for cursor movement
and characters are selected with the Small knob.
NOTE: When editing values, turn the Large knob counter-clockwise to
backspace or move the cursor to the left.
4. As each value is selected, the cursor will advance to the next
character. Touch the necessary key for the desired values.
5. When finished with the Lat/Lon selections, touch the Enter
key.
6. When finished with all selections, touch the Create key to
create the new waypoint.
8.7.2

Waypoint Location Based on Two Radials

1. From the Create User Waypoint page, touch the Position Type
key and then the Radial/Radial key.
Touch to Select
Radial/Radial Waypoint
Reference Type
Figure 8-25 Waypoint Info - Create User Waypoint Type - Radial/Radial
2. Touch the Ref Wpt key and use the alphanumeric keypad to
select the desired identifier.
3. Touch the upper Radial key and use the alphanumeric keypad
to select the desired value.
4. Touch the Enter key.
5. When finished with all selections, touch the Create key to
create the new waypoint.
190-01007-03 Rev. D Garmin GTN 725/750 Pilot's Guide
Foreword
Getting
Started
Audio &
Xpdr Ctrl

Com/Nav

FPL
Direct-To
Proc
Charts
Wpt Info
Map
Traffic
Terrain
Weather
Nearest
Services/
Music
Utilities
System
Messages
Symbols
Appendix
8-19
Index