Laser Installation Ptz140 - GE Everest Ca-Zoom 6.2 Operating Manual

8.8 Laser Accessory Installation (PTZ40)
Step 1.
Locate the Schrader air valve on the pan and tilt section of the camera. Remove
the Schrader air valve cover.
Step 2.
Release the pressure from the camera head (fig. 11)
Step 3. Remove the three screws from the laser mounting plate on camera head (fig. 12)
Figure 
Step 4.
The laser accessory has a wire and connector assembly. Connect to mating con-
nector from camera head (fig. 13)
Step 5. Make sure the 'o' ring is in place on laser mounting plate. Place laser accessory
flush to mounting plate surface and tighten mounting screws (fig. 14)
Figure 3
In order to insure the integrity of the camera system with laser accessory, the camera head needs
to be pressure tested. See "Pressure Testing" section on page 82.
®
Everest Ca-Zoom 6.2
7
Figure 2
Figure 4