Camera Module; Replacement - Ptz100 - GE Everest Ca-Zoom 6.2 Operating Manual

4.8 Camera Module Replacement - PTZ00
CAUTION !
Before performing any maintenance task, be sure to de-pressurize the camera unit via the shrader
valve.
Follow these steps to replace the camera module in the event of camera failure:
• Remove the back cover from camera housing by unscrewing the 8 Phillips screws around the
edges (fig. 51).
• Lift off cover by applying some pressure to slide it sideways.
• Locate the video harness and pull free from camera housing (fig. 52)
Figure 5
• Detach black video connector harness and gently pull to the left side out of the way (fig. 53).
• Locate the power harness and unplug from the circuit board by gently pulling on the wires
(fig. 54).
• Gently pull to the left side out of the way.
Figure 53
®
Everest Ca-Zoom 6.2
77
Figure 52
Figure 54