15 Troubleshooting
Problem
System will not turn on
No power to camera head
Power is on but picture is
snowy or colored
No picture on external video
monitor
For any software problems, turn system power off for 10-15 seconds. Turn on to reboot the
system. If software problems still exist, contact factory for assistance.
Cause
Not plugged in
•
CCU may have been turned
•
on with no cable attached.
Cable may have been
•
disconnected with power on.
Camera is not connected
•
Cable not seated properly at
•
Pan & Tilt
Video output cable is not
•
connected properly
®
Everest Ca-Zoom
6.2
83
Remedy
Check power cord for
•
proper connection to
properly grounded 110/240
VAC 50/60 Hz outlet
Turn system power off for
•
2 minutes to allow circuit
to reset.
Turn system power off and
•
connect camera
Reconnect Cable
•
Connect proper video cable
•
to Video In of monitor