Camera Window; Replacement - Ptz100 - GE Everest Ca-Zoom 6.2 Operating Manual

76
4.7 Camera Window Replacement - PTZ00
CAUTION!
Before performing any maintenance task, be sure to de-pressurize the camera unit via the
Schrader valve (see page 11). Make sure unit is cooled down completely. Lamps are extremely
hot.
To replace the camera window, follow these steps:
• Remove the camera window-retaining ring using the by gently prying the end of the ring with
a small screwdriver
• Gently pry the window out of the housing
• Carefully remove the o-ring from the groove with the supplied o-ring pick
• Clean o-ring groove thoroughly.
• Replace o-ring with a new, well-lubricated o-ring.
• Replace camera window.
• Install retaining ring by starting on one end and working around the camera housing until the
entire ring is inserted into the groove.
• Pressure test camera housing. See "Pressure Testing" section on page 82.
Figure 47
Figure 49
®
Everest Ca-Zoom 6.2
Figure 48
Figure 50