Lsi 1078 Controllers; Configuration: Two Hdds Using One Lsi 1078 Controller - Fujitsu PRIMERGY SX940 Manual

Different configurations
5.2

LSI 1078 controllers

5.2.1 Configuration: Two HDDs using one LSI 1078
controller
Ê Remove the storage blade as described in
blade" on page
Ê Open the storage blade as described in
on page 14.
Prerequisites
No controller installed, HDDs not connected.
5
1
Figure 15: Configuration: Two HDDs using one LSI 1078 controller
Ê Plug the controller into the contact strip (1) of the main board #1 and fix it
with a screw C26192-Y10-C68 (blue circle).
Ê Plug the connector named HOST of the lower SAS cable into the SAS
connector MLC1 (2) on the controller.
Ê Plug the connector named P1 of the lower SAS cable into the connector on
the HDD diskbay 2/3 (3).
Ê Please check, whether the plug P1 of the upper SAS cable is plugged into
the connector of the HDD diskbay 0/1 (4). If it's not, plug it in there.
SX940
13.
2
Review
LSI 1078 controllers
section "Removing the storage
section "Opening the storage blade"
4
3
29